AccountGuest Edition My Account My Log In

Archives :: New Products & Services

Displaying 41 - 60 of 2365 stories.
May 1, 2014
The Kenics KMX-V static mixer utilizes cross-stream mixing and flow splitting to achieve very rapid blending. Suitable for both laminar flow and applications with high or low viscosity...
May 1, 2014
Using PAT to monitor and control granulation Malvern Instruments Granulation is an important operation used for tableting, but its control can be challenging. The Parsum inline particle-sizing probe is being used as a PAT (process analytical technology) instrument in granulation research being conducted at Ghent University in Belgium. The instrument is being used to continuously monitor the granulation...
May 1, 2014
The XD+ range of desiccant dryers utilize the heat of compression from oil-free compressors to dry compressed air. They apply zero-purge cooling with two design variants to...
May 1, 2014
This new vacuum receiver separates solids from air streams using filter media and gravity, and is suitable for applications in which materials contain small particles that are prone to dusting or when dust containment is a primary requirement. The unit features a flap-type dump...
May 1, 2014
The Encompass valve-bagging filling system consists of one or two valve bag fillers, an ultrasonic sealer and a robotic bag applicator, all of which are completely enclosed to contain dust within the...
May 1, 2014
The Combiflux line of pumps is now available with the new FBM-B 3100 brushless battery motor. Especially suitable for transferring small volumes out of narrow openings and difficult-to-access containers...
May 1, 2014
This loop-powered particulate-matter flow and emissions monitor also detects filter leaks in baghouses, cartridge dust collectors and cyclones. Simple...
May 1, 2014
The SFT-250 supercritical fluid extractor is designed for extractions in supercritical fluids in both laboratory and small-scale pilot applications. The unit is forged from 17-4-PH stainless steel, making it...
April 1, 2014
The T23 mass flow controller contains no moving parts and has no obstructions to the flow path, making them capable of performing in applications where there is very...
April 1, 2014
The LPD series of loop-powered bargraphs, available in vertical or horizontal configurations, can be installed in parallel as a replacement for analog loop meters. In the event...
April 1, 2014
The OLK-441 Leak Detection Kit is designed for use with hydraulic systems, compressors, engines, gearboxes and fuel systems. The kit includes the Opti-Lux 400, a flashlight that features a high-output violet light-emitting...
April 1, 2014
The a-Baratron Capacitance Manometer has a high tolerance to ambient temperature changes. Internally heated to 45, 80 or 100°C, this manometer offers full-scale...
April 1, 2014
The SFC 30 and SFC 30S compressors are variable-drive rotary screw compressors with updated specific-power features, including a direct-drive design, premium efficiency motors, lower internal pressure...
April 1, 2014
The ST75 Air/Gas Flowmeter measures fuel gas, process gas, inert gas, waste gases and air in a variety of small line sizes. Designed to optimize air-gas ratio for control of burners in boilers, ovens and heaters, this flowmeter provides three outputs; the mass...
April 1, 2014
The PowerStak line of compact fully powered stackers have been updated with new ergonomic features. The units are built on a short, stable wheelbase to enhance maneuverability, even in tight quarters. An ergonomically designed handle puts all controls...
April 1, 2014
The world’s largest environmental technology trade show, IFAT (, takes place in Munich May 5–9. A record of nearly 3,000 companies from 50 countries are presenting innovations and services in water, sewage, waste and raw materials management, covering some 230,000 m2 of exhibition space. What follows is a small sample of new products being exhibited at the show.   Bürkert...
April 1, 2014
The Sahara Hot Room Model S32 oven can quickly melt materials in drums or totes. Capable of heating 32 drums on pallets (or eight totes), the Sahara Hot Room S32 can use...
April 1, 2014
The VS Series Multijector vacuum conveyor can transfer materials at a wide range of flowrates — from as little as 10 lb/h to as much as 12,000 lb/h over distances up to 200 ft, when used...
April 1, 2014
This company’s line of rigid couplings are offered in one-, two- and three-piece designs, with a variety of configurations and sizes for connecting...
March 1, 2014
Safety glove for broader industrial use Superior Glove Works This company has harnessed an advanced knowledge of yarn technology to create an affordable and innovative glove, allowing a broader industrial market of workers to benefit from premium safety solutions. The Dexterity Ultrafine 18-Gauge Cut-Resistant Glove (photo) is said to be incredibly dexterous, allowing a sleeker fit and improved finger...
Pages: « Previous  1 2 [3] 4 5 6 7 8 9 10 11 12 Next »

Get more from
Get email updates in your inbox


Subscribe to:
Chemical Engineering Magazine

Chemical Engineering Magazine and Archives

Plant Cost Index

Join us on... Twitter LinkedIn

LinkedIn Groups

Our LinkedIn group is now over 28,000 members strong!

  1. Join other CPI professionals from all over the globe and share best practices, expertise, concerns and more.
  2. Provide feedback to Chemical Engineering Editors

Current members represent Worley Parsons, DuPont, SABIC, Fluor, Air Products, LyondellBasell, Nalco, Dow Chemical, Dow Corning, BASF, Jacobs Engineering, ExxonMobil, Shell, Chevron and more.

Join Now

We also offer the following subgroup for more targeted discussions:

Search the Buyers' Guide

Plant Cost Index

Facts at Your Fingertips (archive)

Ask the Experts

Back Issues
To access this area, please log in or create an account.
Forgot your password?
Request it now.
Live chat by BoldChat