Mobile Navigation

New Products

This silencer helps protect workers from gas process noise

The Fisher WhisperTube Modal Attenuator (photo) was introduced recently for noisy gas or vapor applications. The modal attenuator is a full-bore device offering 15-dB sound suppression to reduce noise inside pipes produced by sources upstream, such as control valves, pressure-relief…

This heat exchanger provides 330°F air for drying process

The custom designed three-stage heat exchanger (photo) will be used to increase temperature of a 25,000 std. ft3/min airflow from 50°F to 330°F using 145 psig steam. Each stage is nearly 7 ft tall and 8 ft wide. Heated air…

These bolt washers are also tension sensors

This company has introduced a range of ultra-low profile bolt-load washers that is ideal for bolt-load and tensioner tool calibration. Called TensionDisc (photo), the washers are specially designed load sensors that monitor bolt loads in bolted joint assemblies. A simple…

Condition monitoring for optimizing drive systems

Condition monitoring for predictive maintenance (photo) is a drive solution that focuses on status-oriented maintenance rather than traditional time-based maintenance. Status and drive data are recorded periodically or continuously via the programmable logic controller (PLC) output parameters and can be…

A pair of evaporators for well plates

The TurboVap 96 Dual (photo) is a second-generation well plate evaporator system with two separate, and independently controlled evaporation compartments. The TurboVap 96 Dual has been designed to support enhanced well-plate evaporation within the sample-preparation workflow. With its unique two-in-one…

A compact controller with integrated I/Os

The Compact Controller 100 (photo) is a small controller with integrated input/outputs (I/Os) that is suited for smaller automation solutions. Thanks to its design as a DIN-rail built-in installation device according to DIN 43880, the new controller can also be…

Decentralized I/O solutions for the Ex area

This company has approved its IP67 block input/output (I/O) modules (photo) for the TBEN-S and TBEN-L versions for use in Zone 2 areas. The company is said to be the first supplier to enable cabinet-free decentralized automation solutions with ATEX…

A balance enclosure for critical weighing procedures

The VSE balance enclosure (photo) is offered in widths of 24, 36 and 48 in., in order to accommodate an analytical balance and other small-scale laboratory processes. Constructed of chemical-resistant metal framing and 1/4-in. thick clear acrylic side panels and…

A new volume for this family of bead mills

The Cenomic Optima bead mill (photo) has a range of technological improvements that result in higher flowrates, higher power inputs and improved cooling to deliver up to 25% higher productivity than previous mills of the Cenomic family. The Cenomic Optima…

Leveraging digitalization to optimize hygienic processing

The new CM Connect (photo) is a subscription-based condition monitor and cloud gateway. It enables plant operators to access rotating-equipment data on processing lines from a remote location. With data on actual runtime, trend analysis and time to next service…